|
Do not open the paste sachet until you are ready to
apply the paste and have prepared the area. Once opened, use immediately,
re-sealing between applications if possible. - Air causes the paste to dry
out very quickly. |
|
1. |
Clean wart/mole with the antibacterial swab. |
|
2. |
Gently scratch all surfaces
to be treated with the sterile needle. Scratching should be hard enough so
that when the paste is applied it will penetrate the wart/mole surface. |
|
|
|
- If you are preparing a wart, you may prefer to use a
clean, medium grit emery board.
or
- If you are preparing a skin tag, you may prefer to use a clean, medium
grit emery board. |
|
3. |
Cut a small corner off of the paste sachet
with a pair of scissors; fold the cut corner and re-seal the sachet with a
tab of sticky tape. Now that the sachet is prepared you are ready to
begin. Re-open the sachet; now use the tip of an applicator to dip into
the white paste. Re-seal the sachet. |
4. |
Using the tip of the applicator, apply a thin layer of the paste until
surface of wart/mole is fully covered. Use only enough paste to cover
the affected area and avoid applying to the surrounding skin. |
| 5. |
Allow the
paste to dry for 20 minutes. Then dab off with a clean, wet cotton
bud. |
|
|
|
- If you are removing a mole that is thicker than 3mm
then repeat steps 4 & 5.
or
- If you are removing a wart, then repeat steps 4 & 5. If necessary repeat
to a maximum of 3 applications of paste.
or
- If you are removing a skin tag that is more than 3mm in diameter then
repeat steps 4 & 5.
|
|
If you have successfully treated the area you will
experience a stinging sensation and the area will be completely black and
shrivelled. |
6. |
Apply the skin healing gel. Continue to apply the skin healing gel 2-3
times per day. |
|
7. |
The black area will scab. The scab should be
allowed to fall off naturally. This normally happens between 7 and 21
days. The skin new skin will be red. Allow time for the pigmentation to
fade. |
[Important Notes] |
|
1. |
If bleeding occurs while scratching,
simply wipe clean and apply the mole & wart paste. |
|
2. |
Certain types of
warts/moles are very hard. Simply scratch harder so as to penetrate outer
layer and allow for the paste to enter. If stinging sensation is not felt,
it means the paste has not penetrated the wart/mole. Scratch and reapply. |
|
3.
|
Be careful not to disturb or remove scab as
premature removal can lead to scarring. Let it fall off naturally.
|
|
4. |
Redness on skin around treated wart/mole is a
natural occurrence and quickly disappears. |
|
5. |
Avoid paste contact with normal skin. Should
contact occur, scrape off with the unused end of an applicator. |
[Precautions] |
|
1. |
Persons with keloids or other tissue disorders
should not use this product. |
|
2. |
This product is for raised warts, moles and
skin tags only. |
|
3. |
If the paste gets into eyes, flush
thoroughly with water. If unusual discomfort arises, consult a physician. |
| 4. |
Keep out of reach of children. |